Specifications

98 CY8CKIT-042 PSoC 4 Pioneer Kit Guide, Doc. # 001-86371 Rev. *D
Advanced Topics
Figure 6-49. Programming Finished Successfully
7. The factory program is now successfully restored on the PSoC 5LP. It can be used as the pro-
grammer/debugger for the PSoC 4 device.
6.4.2 PSoC 5LP is Programmed with a Standard Application
If PSoC 5LP is programmed with a standard application, restore the factory program by using the fol-
lowing method.
1. Launch PSoC Programmer 3.18 or later from Start > Cypress > PSoC Programmer.
2. Use the File > Open menu to load the KitProg.hex factory program hex file, which is shipped with
the kit. The default location for this file is: <Install Path>\CY8CKIT-042 PSoC 4 Pioneer
Kit\<version>\Firmware\Programmer\KitProg
3. Connect a CY8CKIT-002 MiniProg3 (sold separately) to the computer. The 10-pin connector
cable on the MiniProg3 plugs into the header [J7]. Note that the J7 header is unpopulated. For
more details, see A.6 Bill of Materials (BOM) on page 108.