Specifications

7. Operation Controls and Functions
The following sections describe the hardware components of the unit.
7.1 Front Panel
① ② ⑩③ ④ ⑤ ⑥ ⑦ ⑧ ⑨
①
LCM monitor: This monitor displays your settings information with each
output and input selection.
②
IR sensor.
③
POWER: Press this button to turn the system on. Once the system turns on
the LED will turn Green and when entering Standby Mode it will turn Red.
Once the system turns on the LED will turn Green and when entering
Standby Mode it will turn Red.
④
EDID: There will be two selections shown on the LCM: 1. TV mode and
2.Standard Mode, press the number key to first select the desired input
and then press one or two to select the EDID mode. The LED will turn on
when setting the EDID. After the selection is made, press enter key to
confirm. Standard mode means the device will use internal built-in EDID
and TV mode means the device will use TV/display
’
s EDID. When EDID is
in TV mode,
Notes:
1. When EDID is switched to a TV the device will first detect the HDMI
output source
’
s EDID from A-D and then record it in the unit regardless
of the HDMI output source from E-H. If the first detected output source is
DVI it will pass on to the next source, until the first HDMI is detected. The
detection priority is HDMI v1.3 > HDMI v1.2 > DVI. In order to ensure all
output is displayable output from E-H must be of a lower standard then
output from A-D.
2. When EDID is on STD, the device will use the built-in EDID
Video Supports < 1080p 10 bits (max)
Audio Supports = PCM2
5