User manual

(6). Remote Control

1. Power: Power ON/OFF button.

2. Display: Press the button to enable or disable the on screen display

of the resolution information.

3. C-Video: Press the button to select composite video as input source.

4. S-Video: Press the button to select S-Video as input source.

5. YCbCr: Press the button to select YCbCr as input source.

6. PC: Press the button to select PC input looping through to the output.

7. VGA: Press the button to select 640 x 480 as output resolution.

8. SVGA: Press the button to select 800 x 600 as output resolution.

9. XGA: Press the button to select 1024 x 768 as output resolution.

10. SXGA: Press the button to select 1280 x 1024 as output resolution.

11. 480p: Press the button to select 852 x 480p as output resolution.

12. 576p: Press the button to select 852 x 576p as output resolution.

13. 720p: Press the button to select 1280 x 720p as output resolution.

14. 1080i: Press the button to select 1920 x 1080i (interaced) as output resolution.

15. Aspect ratio: Press the button to switch between standard, 4:3 and

wide (16:9)aspect ratio.

16 IR-Set: When IR sensor is turned off by RS-232, Press this button for

over 15 seconds will turn on the IR sensor.

17. 3D: Press to turn ON/OFF the 3D enhance.

18. NR: Press to turn ON/OFF digital noise reduction.

19. Mode: Same as "mode" button on front panel.

press to toggle through

Source ResolutionOutput

Aspect3D EnhanceDigital NR

Source

20. Picture: Same as picture button on

front panel. Press to toggle

through Contrast Bright

Color  Tint  Sharpness

Contrast

21. Reset: Press this button will revert picture

adjust back to factory preset value.

2 9