Specifications

4
① Power: Press to turn the system on/off.
② ID: Press the Transmitter and Receivers “ID” button for 2 seconds to connect
the systems. These systems were already connected before leaving the
factory, so you do not need to reset them again unless the system cannot
link up properly. Press the ID button for more than 10 seconds to switch to a
different mode (Broadcast/Unicast). When the green LED is lit it means the
system is under Unicast mode and when the red LED is on, it means the
systems has been switched to Broadcast mode. The factory default is
Unicast mode and it is suggested to use this for household use. It is not
necessary to press both the Transmitter and Receiver's ID button at the same
time. Note: Due to the nature of the transmission, Broadcast mode has no
uplink so bi-directional communication between Transmitter and Receiver is
not possible. This results in the following limitations:
③ IR sensor.
④ Power: The LED will illuminate when power ON.
⑤ Link: When under search mode the LED will flash repeatedly and during the
signal linking stage the LED will slowly flash. When the LED has been switched
on and no longer flashes it means the signal has been properly linked.
4.2.2 Rear Panel
① HDMI output: Connect the HDMI output to the HDMI input of your display
using an HDMI cable.
② Power: Plug the 5V DC power supply into this unit and connect the adaptor
to an AC outlet.
1 2
HDMI OUT
DC 5V
5. Remote Control
①. Power: Press to turn the device on/off.
②. ID: Press the transmitters and receivers “ID”
button for two seconds to connect the system.
These systems were already connected before
leaving the factory so you do not need to reset
them again unless the system cannot link up
properly.
③. 1~3: Input source selection of 1~3, press to have
your desired source displayed on the HDMI
display.
CR-67
IDPOWER
INPUT
1
2
3
Transmitter
CR-68
IDPOWER
Receiver
①
②
①
②
③