Specifications

7
8. Troubleshooting
Situation Check Point
Power LED is not
illuminate when power
ON.
1.
adaptor.
2. Check all power connectors are plugged in
correctly.
3. Push the power buttons to turn on the devices.
1. Check if source’s timing is supported by the
device. The device support up to 1080i and
therefore, please make sure the source is sending
acceptable timing for device and display and
the display also can accept that timing.
2. Check if both source and the display are
HDCP/CEC complaint.
3. Check if TV mode is selected rightly.
4. Check if both source and display are connected
stably.
1. For the first time linkage, if the output display is not
link up the input LED will not illuminate therefore,
please check if the HDMI output is connected.
Different color on Power
LED.
Check if the right adaptor is used. 5V 2.6A’s
The Link’s LED is
illuminating consistently
without image display
or unexpected image
display.
Input’s LED not
illuminate.
After powering on
Tx & Rx the Link’s LED
is flashing speedily /
slowly without image.
1. Red Power LED means under Broadcast mode
and Green Power LED means under Unicast mode.
If Tx is on Green LED but Rx is on Red LED, press Rx's
ID key for 10 second to change to Unicast mode.
Vice versa, when Broadcast mode is demanded
press Tx's ID key for 10 second to change to
Broadcast mode.
1. This is normal if the devices are pairing or learning,
the LED will illuminate slowly when it is doing signal
linking. After signal is transmit and received
steadily the LED will be light up consistently.
2. If the LED keeps on flashing speedily for more than
3 minute, then repairing devices by pushing the
ID keys for 2 second.
3. If the LED keeps on flashing slowly for more than
3 minute, then check the input selection of the
transmitter if its correct.