Specifications

CY14B104K, CY14B104M
Document #: 001-07103 Rev. *O Page 23 of 33
Software Controlled STORE and RECALL Cycle
In the following table, the software controlled STORE and RECALL cycle parameters are listed.
[28, 29]
Parameters Description
25 ns 45 ns
Unit
Min Max Min Max
t
RC
STORE/RECALL Initiation Cycle Time 25 45 ns
t
SA
Address Setup Time 0 0 ns
t
CW
Clock Pulse Width 20 30 ns
t
HA
Address Hold Time 0 0 ns
t
RECALL
RECALL Duration 200 200 μs
t
SS
[30, 31]
Soft Sequence Processing Time 100 100 μs
Switching Waveforms
Figure 13. CE and OE Controlled Software STORE and RECALL Cycle
[29]
Figure 14. Autostore Enable and Disable Cycle
t
RC
t
RC
t
SA
t
CW
t
CW
t
SA
t
HA
t
LZCE
t
HZCE
t
HA
t
HA
t
HA
t
STORE
/t
RECALL
t
HHHD
t
LZHSB
High Impedance
Address #1 Address #6Address
CE
OE
HSB(STOREonly)
DQ (DATA)
RWI
t
DELAY
Note
32
t
RC
t
RC
t
SA
t
CW
t
CW
t
SA
t
HA
t
LZCE
t
HZCE
t
HA
t
HA
t
HA
t
DELAY
Address #1 Address #6Address
CE
OE
DQ (DATA)
t
SS
Note
32
Notes
28. The software sequence is clocked with CE
controlled or OE controlled reads.
29. The six consecutive addresses must be read in the order listed in Table 1. WE
must be HIGH during all six consecutive cycles.
30. This is the amount of time it takes to take action on a soft sequence command. V
CC
power must remain HIGH to effectively register command.
31. Commands such as STORE and RECALL lock out I/O until operation is complete which further increases this time. See the specific command.
32. DQ output data at the sixth read may be invalid since the output is disabled at t
DELAY
time.
[+] Feedback