36-Mbit DDR-II+ SRAM 2-Word Burst Architecture (2.5 Cycle Read Latency) Specification Sheet

CY7C1266V18, CY7C1277V18
CY7C1268V18, CY7C1270V18
Document Number: 001-06347 Rev. *D Page 9 of 27
Delay Lock Loop (DLL)
These chips use a DLL that is designed to function between 120
MHz and the specified maximum clock frequency. The DLL may
be disabled by applying ground to the DOFF
pin. When the DLL
is turned off, the device behaves in DDR-I mode (with 1.0 cycle
latency and a longer access time). For more information, refer to
the application note, DLL Considerations in
QDRII/DDRII/QDRII+/DDRII+. The DLL can also be reset by
slowing or stopping the input clocks K and K
for a minimum of 30
ns. However, it is not necessary for the DLL to be reset to lock to
the frequency you want. During power up, when the DOFF is tied
HIGH, the DLL is locked after 2048 cycles of stable clock.
Application Example
Figure 1 shows two DDR-II+ used in an application.
Figure 1. Application Example
Truth Table
The truth table for CY7C1266V18, CY7C1277V18, CY7C1268V18, and CY7C1270V18 follows.
[2, 3, 4, 5, 6, 7]
Operation K LD R/W DQ DQ
Write Cycle:
Load address; wait one cycle; input write data on consecutive
K and K
rising edges.
L-H L L D(A) at K(t + 1) ↑ D(A + 1) at K(t + 1) ↑
Read Cycle: (2.5 cycle Latency)
Load address; wait two and half cycle; read data on consec-
utive K
and K rising edges.
L-H L H Q(A) at K
(t + 2) ↑ Q(A + 1) at K(t + 3) ↑
NOP: No Operation L-H H X High-Z High-Z
Standby: Clock Stopped Stopped X X Previous State Previous State
BUS
MASTER
(CPU or ASIC)
DQ
Addresses
Cycle Start
R/W
Source CLK
Source CLK
Echo Clock1/Echo Clock1
Echo Clock2/Echo Clock2
R = 250ohms
LD R/W
DQ
A
SRAM#1
K
ZQ
CQ/CQ
K
R = 250ohms
LD R/W
DQ
A
SRAM#2
K
ZQ
CQ/CQ
K
Notes
2. X = “Don’t Care,” H = Logic HIGH, L = Logic LOW, ↑
represents rising edge.
3. Device powers up deselected with the outputs in a tri-state condition.
4. “A” represents address location latched by the devices when transaction was initiated. A + 1 represents the address sequence in the burst.
5. “t” represents the cycle at which a read/write operation is started. t + 1, t + 2, and t + 3 are the first, second, and third clock cycles succeeding the “t” clock cycle.
6. Data inputs are registered at K and K
rising edges. Data outputs are delivered on K and K rising edges.
7. Cypress recommends that K = K
= HIGH when clock is stopped. This is not essential, but permits most rapid restart by overcoming transmission line charging
symmetrically.
[+] Feedback [+] Feedback