Specifications

CY7C67200
Document #: 38-08014 Rev. *H Page 5 of 85
UART Features
■ Supports baud rates of 900 to 115.2K
■ 8-N-1
UART Pins
I
2
C EEPROM Interface
EZ-OTG provides a master-only I2C interface for external serial
EEPROMs. The serial EEPROM can be used to store applica-
tion-specific code and data. This I2C interface is only to be used
for loading code out of EEPROM, it is not a general I2C interface.
The I2C EEPROM interface is a BIOS implementation and is
exposed through GPIO pins. Refer to the BIOS documentation
for additional details on this interface.
I
2
C EEPROM Features
■ Supports EEPROMs up to 64 KB (512K bit)
■ Auto-detection of EEPROM size
I
2
C EEPROM Pins
Serial Peripheral Interface
EZ-OTG provides an SPI interface for added connectivity.
EZ-OTG may be configured as either an SPI master or SPI slave.
The SPI interface can be exposed through GPIO pins or the Ex-
ternal Memory port.
SPI Features
■ Master or slave mode operation
■ DMA block transfer and PIO byte transfer modes
■ Full duplex or half duplex data communication
■ 8-byte receive FIFO and 8-byte transmit FIFO
■ Selectable master SPI clock rates from 250 kHz to 12 MHz
■ Selectable master SPI clock phase and polarity
■ Slave SPI signaling synchronization and filtering
■ Slave SPI clock rates up to 2 MHz
■ Maskable interrupts for block and byte transfer modes
■ Individual bit transfer for non-byte aligned serial communi-
cation in PIO mode
■ Programmable delay timing for the active/inactive master SPI
clock
■ Auto or manual control for master mode slave select signal
■ Complete access to internal memory
SPI Pins
The SPI port has a few different pin location options as shown in
Table 7. The pin location is selectable via the GPIO Control reg-
ister [0xC006].
High-Speed Serial Interface
EZ-OTG provides an HSS interface. The HSS interface is a pro-
grammable serial connection with baud rate from 9600 baud to
2M baud. The HSS interface supports both byte and block mode
operations as well as hardware and software handshaking. Com-
plete control of EZ-OTG can be accomplished through this inter-
face via an extensible API and communication protocol. The
HSS interface can be exposed through GPIO pins or the External
Memory port.
HSS Features
■ 8-bit, no parity code
■ Programmable baud rate from 9600 baud to 2M baud
■ Selectable 1- or 2-stop bit on transmit
■ Programmable intercharacter gap timing for Block Transmit
■ 8-byte receive FIFO
■ Glitch filter on receive
■ Block mode transfer directly to/from EZ-OTG internal memory
(DMA transfer)
■ Selectable CTS/RTS hardware signal handshake protocol
■ Selectable XON/XOFF software handshake protocol
■ Programmable Receive interrupt, Block Transfer Done inter-
rupts
■ Complete access to internal memory
Table 5. UART Interface Pins
Pin Name Pin Number
TX B5
RX B4
Table 6. I
2
C EEPROM Interface Pins
Pin Name Pin Number
SMALL EEPROM
SCK H3
SDA F3
LARGE EEPROM
SCK F3
SDA H3
Table 7. SPI Interface Pins
Pin Name Pin Number
nSSI F6 or C6
SCK D5
MOSI D4
MISO C5