LUPA Demo Kit User Guide Cypress Semiconductor Corporation • 3901 North First Street • San Jose, CA 95134 • 408-943-2600 Revised December 5, 2005 [+] Feedback
LUPA Demo Kit User Guide Table of Contents 1.0 GENERAL DESCRIPTION ............................................................................................................... 3 1.1 Introduction ................................................................................................................................. 3 1.2 Test System Hardware ............................................................................................................... 3 1.3 Multifunctional Digital Boards ........
LUPA Demo Kit User Guide 1.0 General Description This guide allows the user to install and run the demo kit properly. The hardware installation and the software installation are described. All necessary software and hardware drivers to run the demo kit properly are included on the disk. Evaluation software (Win 2000 & XP) allows the users to make an evaluation of the LUPA300 sensor and its functionalities. 1.
LUPA Demo Kit User Guide 2.0 Demo Kit Set-up 2.1 Software Installation The CD-ROM contains a set-up file (setup.exe), which will launch an install shield. This install shield will install the Cypress Demo Software onto the PC properly. NOTE: The software will only work under Win 2000 or XP. It will not work under Win 95, 98, or NT! 2.
LUPA Demo Kit User Guide 3.1 Basic Operation To start operating the sensor, just press the “Start” button. You will be asked to point to a .dset file that contains the necessary settings to operate the sensor. By default only one .dset file is installed with the software so please select this one. After the selection of the file with the default parameters (dset file) two displays will pop up in which the images will be shown, one for B&W images and one for the color reconstructed images.
LUPA Demo Kit User Guide 5.0 Contact General information on product price and availability: Myriam Gillisjans Tel +32 15 446+356 Fax +32 15 446 344 fgi@cypress.com Product and software support: Pieter Willems Tel +32 15 446 389 Fax +32 15 446 344 ffpw@cypress.com All product and company names mentioned in this document are the trademarks of their respective holders. UG5005 approved kkvtmp 12/5/05 Page 6 of 6 © Cypress Semiconductor Corporation, 2005.