Specifications

"
The handheld units are shipped preconfigured for use with their respective Central Units.
One Handheld is designated as "Out Bound" and has the polling address of 0 (zero).
Another is labelled as "Inbound" with address 1. And the third handheld is set up as a
spare unit with a polling address of 2 (not in the central unit's polling sequence).!
!
At any time, the spare can be easily re-configured to take over for the In or Out handheld
device by using special programming cards (included with your units). All units will
recognize the 3 programming cards (they are not restricted to a particular set or group of
handhelds).!
!
The programming cards ( PART NUMBER WMR-PRCD) are labeled Address 0, 1, and 2.!
!
Change the spare unit to take over for the outbound handheld reader:!
1. Turn the spare handheld on by pressing the power button momentarily!
2. Observe the Red Led is on solid.!
3. Present the Programming Card labelled Address 0!
4. Observe the Red Led wink for 1/2 second indicating the card was read (there is also an
audible beep)!
5. The Blue Led should start blinking every second indicating that it is communicating with
the Central Unit!
6. The Handheld is now ready to be used as the OutBound Handheld Reader!
!
!
Change the spare unit to take over for the inbound handheld reader:!
1. Turn the spare handheld on by pressing the power button momentarily!
2. Observe the Red Led is on solid.!
3. Present the Programming Card labelled Address 1!
4. Observe the Red Led wink for 1/2 second indicating the card was read (there is also an
audible beep)!
5. The Blue Led should start blinking every second indicating that it is communicating with
the Central Unit!
6. The Handheld is now ready to be used as the InBound Handheld Reader!
ADDRESS PROGRAMMING ADDENDUM!