Specifications

!
!
!
!
Take a handheld out of service:
1. Turn the spare handheld on by pressing the power button momentarily
2. Observe the Red Led is on solid. If not, the batteries may need to be replaced
or charged.
3. Present the Programming Card labelled Address 2
4. Observe the Red Led wink for 1/2 second indicating the card was read (there
is also an audible beep)
5. The Blue Led should stop blinking and remain solid (or stay off) indicating it is
no longer in contact with the Central Unit
6. The Handheld is no longer being polled by the central and will not interfere
with normal use of the other 2 units
!
!
For all steps indicated above, the following error conditions may occur.
!
Step 2 - If the Red LED does not illuminate, the batteries may need to be
replaced or charged.
Step 4 - If you do not see the Red LED wink out for 1/2 second, present the
badge again.
- If the Red LED still does not indicate a badge read has occurred, then there
may be a problem with the reader.
- When trying multiple times, make sure the badge is well away ( greater than 1
foot) from the handheld before presenting the badge again.
- Allow the unit to power off (1 minute) and try again.
Step 5 - If the Blue LED does not start blinking within 10 seconds after
presenting the In or Out programming card, make sure the Central Unit is
powered on and is within communication range. After presenting the "Out of
Service" card (Address 2), the Blue LED should stop blinking within 10 seconds.
If it continues to blink, the Central Unit may not be configured properly.
!