Manual

9439 IRONDALE AVE., CHATSWORTH, CALIFORNIA 91311 USA

888-297-6660 www.CYRON.com

Media Highlighter

IR Controller

HTW1000

Hardwiring Instructions

Thank you for purchasing CYRON HTW1000 Media Highlighter IR controller.

a a a a

To hardwire this system you need ample knowledge of wiring practices.

This option should be done by experienced professionals such as

electricians or certified custom electronic installers. Please contact

CYRON Technical Support for further details. There may be other

options available for your project. CYRON experienced Tech Support

staff will be happy to help you implement your project.

STEP ONE: Open the HTW1000 controller box.

STEP TWO: Take out the PCB to gain access to the hub.

Use minimum 18AWGx4 (4 conductor 18 gauge) wire for extending lightbar

wires up to 100ft. For runs over 100ft you must increase the wire gauge

accordingly.

To minimize the clutter of too many wires at the hub, you should connect as

many lightbars possible to one or few main leads. The main leads can then be

connected to the terminal block.

STEP THREE: Take out the housing wire cap.

STEP FOUR: Connect wires to the hub following the color code shown in

Table One. Note that 12VDC and lightbars wires can all be connected to the

hub. Connecting the 12VDC directly to the hub is required for power supplies

over 60watts. Four terminal inlets have been provided for 12V positive and

negative. For power sources over 100W it is a good idea to use four wires, two

for the positive, two for the negative. This will eliminate extra current being

carried over one wire.

PAGE 1
9439 IRONDALE AVE., CHATSWORTH, CALIFORNIA 91311 USA 888-297-6660 www.CYRON.com Media Highlighter® IR Controller HTW1000 Hardwiring Instructions Thank you for purchasing CYRON HTW1000 Media Highlighter IR controller. a a a a To hardwire this system you need ample knowledge of wiring practices. This option should be done by experienced professionals such as electricians or certified custom electronic installers. Please contact CYRON Technical Support for further details.
PAGE 2
CYRON Media Highlighter Lightbar Wire Color Code CYRON Lightbar Wires HTW1000 Terminal Block (Not the same as HTHUB wires) Green +12V Black B Red G White R TABLE ONE STEP FIVE: Place the PCB back in their positions and close the back cover. Pay close attention to the wires connecting the side PCBs to the main PCB. STEP SIX: Manage the wires. Use zip ties or other means to secure the wires together. As stated in the User Manual, the IR receiver will need to be connected to the IR plug.