User Manual

21
Classic PRE User Instrucons
Remote control learning
In addion to controlling Cyrus components, the remote
control can learn the commands from two other remote
control handsets. These will normally be a TV and a Satellite
or terrestrial TV set-top box, programmed to the TV and
SAT buons, but could also be other audio components
including a Cyrus tuner or DVD player etc.
All keys may be programmed with the excepon of the
groups marked CONTROL and SOURCE and the SETUP key.
Preparaon for learning
Check the following points before aempng to learn any
commands -
• Check that both remote controls have fresh baeries.
• Choose a locaon on a tabletop that is not brightly lit.
Subdued light is beer, away from bright natural or
indoor lighng.
• Check that you have enough me to spare to complete
the learning process for all the keys you want to use.
Learning commands
In this example, the Cyrus remote control will be learning
commands from a ‘reference’ Satellite receiver remote
control.
1. Set the two remote controls up facing each other, spaced
by about 5cm.
12
3
4
5
79
6
8
0/10
SATTV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc
def
ghi jkl
mno
pqrs
tuv wxyz
GUIDE
INFO
TEXT
TV/AV
CONTROL
SOURCE
12
3
4
5
79
6
8
0/10
SATTV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc
def
ghi jkl
mno
pqrs
tuv wxyz
GUIDE
INFO
TEXT
TV/AV
CONTROL
SOURCE
The keypad will light and the key you selected will be red.
2. Press the TV or
SAT key to select
the mode that you
want to program.
3. Press and hold the
SETUP key.
The mode key will change to white. Aer about three
seconds, the mode key will light red again. This indicates
that the remote control is ready to learn codes.
4. Release the SETUP key.
The remote control is now waing to learn commands. The
keypad will light connually and the mode key will light pale
red.
5. On the reference remote control, press and hold the rst
key you want to learn (for example, volume up) unl the
mode key ashes red.
This indicates that the command has been received.
6. Release the key on the reference remote control.
7. Press a key on the Cyrus remote control (volume up
in this example) to select where you want to save that
command.
The mode key will stop ashing. This indicates that the
command has been saved successfully.
If the learning process was successful, the remote control
will be ready to learn the next command.
8. Repeat steps 5 to 7 for each command you want to learn.
When you have completed learning all commands -
• Press the SETUP key.
The mode key will change to white. Aer a few seconds the
backlight will switch o.
12
3
4
5
79
6
8
0/10
SATTV
STORE
MENU
ENTER
SELECT
LIST
CH
SETUP
abc
def
ghi jkl
mno
pqrs
tuv wxyz
GUIDE
INFO
TEXT
TV/AV
CONTROL
SOURCE
1
23
65
4
7
89
0
AUDIO
SUB
TTX
GUIDE
FAV
INFO TV/R
OK
LIST EXIT
AD
ZOOM
MENU
VOL CH
5cm