User's Manual

A
B
C D
E
* Only use certified 18W 9V/2A adapter
*
3-in-1 wireless charging station
3-in-1 wireless charging station
IMPORTANT SAFETY INSTRUCTIONS
* Do not store device in high-temperature
environment, including heat caused by intense
sunlight or other forms of heat. Do not place
device in fire or other excessively hot
environments. Exposure to fire or temperature
above 212°F (100°C) may cause explosion.
* Do not use the wireless charger in excess of its
output rating. Overloading outputs above rating
may result in a risk of fire or injury to persons.
* Do not expose the wireless charger to rain or
snow.
* Do not modify, repair or disassemble the unity,
if so, please contact the manufacturer.
Switch o the wireless charger when not in use.
The wireless charger will automatically switch
o when disconnected from its wall charger.
Before Using the unit, please read
the user manual carefully
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. During the operation of device a
distance of 15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
FCC StatementFCC Statement