User`s manual

Version 1.1
Copyright by
CYTECH 2006
USER’S MANUAL – S/X-SERIES
Do not over tighten the Adjustment
Knob. Make sure the Saddle Post
does not slide while riding.
3
4
M8 Bolt
A
For details please refer to page 25
3. Turn the rear Adjustment Knob (02
10 B) counter clockwise and insert the
Saddle Post (02 21 06 SX) into the
Frame. Next, bring the Saddle Post to
the desired height, and turn the
Adjustment Knob clockwise to
retighten until it is snug.
4. Loosen the M8 Bolt on the lower
side of the aluminium saddle bracket
(02 20 03) several turns without
removing it. Next, turn the upper part
of the Saddle Clamp (A) one quarter of
a turn, and set the rails of the Saddle
(01 21 VL-3134) in the grooves of the
Lower Saddle Clamp (02 20 03). Then,
lift the Upper Saddle Clamp, turn it
back to its original position, and set it
on top of the rails. Finally, firmly
retighten the Bolt and make sure that
the saddle is mounted in its most
horizontal position at the middle of the
rail.
www.indoorcycling.com ENG 6