RisingHF RHF0M301 Datasheet DS01603 RHF0M301 Datasheet V1.2 Document information Info Content Keywords RisingHF, LoRa Gateway, Module Abstract This document shows a product description including performance and interfaces of the concentrator module RHF0M301-xxx.
RisingHF RHF0M301 Datasheet Content Content .................................................................................................................................................. 2 1 Introduction ......................................................................................................................................... 1 1.1 Key Product Features ................................................................................................................... 1 1.2 Applications ..
RisingHF RHF0M301 Datasheet 1 Introduction RHF0M301 is a high performance LoRa/LoRaWAN module based on Semtech SX1301. The SX1301 digital baseband chip is a massive digital signal processing engine specifically designed to offer breakthrough gateway capabilities in the ISM bands worldwide. RHF0M301 integrate the core chip SX1301 with high performance RF front end module include high efficiency PA and low noise figure LNA. SPI interface is provided to customer to access into the registers of the module.
RisingHF RHF0M301 Datasheet 1.3 General descriptions RHF0M301 module is based on Semtech v1.0 LoRaWAN concentrator reference design. A RF switch is used to achieve half duplex mode. Figure 1-1 show a simple block diagram of the module.
RisingHF RHF0M301 Datasheet 2 Electrical Characteristics 2.
RisingHF RHF0M301 Datasheet 2.3 Power consumption Table 2-3 Power consumption of RHF0M301 Status Current/ Unit Normal, 8 Rx CH ON, PA ON 340 mA Normal, 8 Rx CH ON, PA ON (Uplink) Average 590 mA Normal, 8 Rx CH ON, PA ON (Uplink), Peak 660 mA Normal, Standby mode 40 mA Test mode, 8 Rx CH ON 340 mA Test Mode, TX continuous, MAX Output power 395 mA Note: All the test data above is based on the RF port is matching with 50R impedance, RHF0M301-434 used, 25°C Temperature.
RisingHF RHF0M301 Datasheet TX Power Variation （-40 to 85℃） Temperature -1.5 1.5 dB -3 3 ppm Frequency Range（Rx/Tx） Max Output power 470 490 MHz Output Power Variation -1.5 1.5 dB -1.5 1.5 dB -3 3 ppm Frequency Range（Tx） 470 510 MHz Frequency Range（Rx） Max Output power 470 490 MHz Output Power Variation -1.5 1.5 dB -1.5 1.5 dB -3 3 ppm Frequency Range（Rx/Tx） Max Output power 779 787 MHz Output Power Variation -1.5 1.5 dB TX Power Variation Temperature -1.
RisingHF RHF0M301 Datasheet TX Power Variation （-40 to 85℃） Temperature TX Frequency Variation Temperature （-40 to 85℃） V1.2 2016-12-01 www.risinghf.com -1.5 1.
RisingHF RHF0M301 Datasheet 2.5.2 Receiver Sensitivities are given for 32 bytes payload, 10% PER. Table 2-6 Receiver sensitivity Part Number Bandwidth/kHz 125 RHF0M301-434 250 500 125 RHF0M301-470 RHF0M301-470B 250 500 125 RHF0M301-780 250 500 125 RHF0M301-868 250 500 125 RHF0M301-915 250 500 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.3 Frequency response 2.5.3.1 RHF0M301-434 Available band: 430MHz to 437MHz Max TXOP vs Freq 30 20 10 0 -10 -20 -30 420425426427428429430431432433434435436437438439440441442443444445450455 Figure 2-1 Txop vs Freq for RHF0M301-434 Sensitivity vs Freq/SF12,125kHz -134 -135 -136 -137 -138 -139 -140 -141 -142 Figure 2-2 Sensitivity vs Freq for RHF0M301-434 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.3.2 RHF0M301-470/RHF0M301-470B For RHF0M301-470 (the previous version): Available band: 470MHz to 490MHz For RHF0M301-470B(new version): Available band: 470MHz to 490MHz (uplink); 470MHz to 510MHz (downlink); 30 20 10 0 -10 #1 -20 #2 -30 -40 530 520 510 500 498 496 494 492 490 488 486 484 482 480 478 476 474 472 470 468 466 460 450 -50 Figure 2-3 Txop vs Freq for RHF0M301-470 Figure 2-4 Txop vs Freq for RHF0M301-470B V1.2 2016-12-01 www.
RisingHF RHF0M301 Datasheet Sensitivity vs Freq/SF12 125kHz 469 470 471 472 473 474 475 476 477 478 479 480 481 482 483 484 485 486 487 488 489 490 491 492 493 494 495 -128 -130 -132 -134 -136 -138 -140 -142 Figure 2-5 Sensitivity vs Freq for RHF0M301-470 and RHF0M301-470B V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.3.3 RHF0M301-780 Available band: 779MHz to 787MHz Figure 2-6 Txop vs Freq for RHF0M301-780 Figure 2-7 Sensitivity vs Freq for RHF0M301-780 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.3.4 RHF0M301-868 Available band: 859MHz to 871MHz Figure 2-8 Txop vs Freq for RHF0M301-868 Figure 2-9 Sensitivity vs Freq for RHF0M301-868 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.3.5 RHF0M301-915 Available band: 900MHz to 930MHz Figure 2-10 Txop vs Freq for RHF0M301-915 Figure 2-11 Sensitivity vs Freq for RHF0M301-915 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 2.5.4 CW interferer rejection PACKET: CHAN:0 BW:0 SF:7 CR:1 PPM:0 PL(16): 2E 5C 0F 86 56 2D 36 E7 AD 78 E9 1B BF BC 90 2F TEST : CW interferer rejection SETUP : Wanted level: -122 dBm, PER: 50%, max errors: 10, max packets: 20, resolution: 1 dB Test Band: 434MHz RESULT: Figure 2-12 Rx CW blocking immunity V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 3 Application 3.1 Semtech HAL This part will give the output power table for each band. Users should refer to these tables to configure their GW on server side. 3.1.
RisingHF RHF0M301 Datasheet 3.1.
RisingHF RHF0M301 Datasheet 3.1.
RisingHF RHF0M301 Datasheet 3.1.
RisingHF RHF0M301 Datasheet 3.1.
RisingHF RHF0M301 Datasheet 3.2 Reset sequence Each time when powering up the RHF0M301 module, reset operation is compulsive. The input reset signal should be more than 1ms delay after VCC+5V stable. Figure 3-1 Reset sequence 3.3 PPS selection There are two choices for customer to input PPS signal: pin24 of 2.54mm pitch HDR2x12 connector, or J100.
RisingHF RHF0M301 Datasheet 3.4 Reference Design Figure 3-3 Recommended Connection Note: 1) 220uF//220uF//100nF//100pF is strongly suggested to put as close as to the input pin (Pin1 and Pin2) of the module when you layout! 2) A RC filter (R=22R, C=10nF) is strongly suggested to be added for Reset connection. 3.5 Dimension Figure 3-4 Mechanical size of RHF0M301 (Top View) V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet Figure 3-5 Mechanical size of RHF0M301 (Side View) Figure 3-6 Mechanical size of enclosure on board V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 3.6 Package information 3.6.1 Real product photo show Figure 3-7 Top View of RHF0M301 Figure 3-8 Bottom View of RHF0M301 V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet 3.6.2 Silk screen on the product Figure 3-9 Silk screen on the Shield 3.6.3 Package information There will be a label with “RHF0M301-xxx” on the top side of the box. Box size is 150x90x42mm. --RHF0M301-434 is the 434MHz band production. --RHF0M301-470 is the 470MHz band production. --RHF0M301-780 is the 780MHz band production. --RHF0M301-868 is the 868MHz band production. --RHF0M301-915 is the 915MHz band (902MHz to 928MHz) production. Figure 3-10 Box for packaging V1.
RisingHF RHF0M301 Datasheet Figure 3-11 Package of the module V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet Revision V1.2 2016-12-02 + update with package information V1.1 2016-11-18 + update with new specifications and block diagram V1.0 2016-09-12 + Creation V1.2 2016-12-01 www.risinghf.
RisingHF RHF0M301 Datasheet Please Read Carefully: Information in this document is provided solely in connection with RisingHF products. RisingHF reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All RisingHF products are sold pursuant to RisingHF’s terms and conditions of sale.
