User Manual

Once the two PL-48S_2 have been attached
to the boxes (3) using one safety pin per piece, the PL-
48S_1 pieces can be attached. Remove the safety
pins (4)and insert the PL-48S_1pieces into the rigging
hardware (5) securing them (6) by using two pins per
piece.
Once the PL-48S_1 and PL-48S_2 have
been secured to the lower box, this should be lowered
so that the PL-48S_1 piece can be secured to the PL-
48Splatform(7)usingthesafetypins.
62Aero-38 Manual del usuario/ User´s manual
Release the PL-48S_2 piece by removing
the safety pins (1). Next, swing the pieces and
introduce them (2) into the rear rigging hardware of
thelowestbox,securingthemwiththesafetypin(3).
1
2
6
4
5
3
7
G2A48
Quick release pin
must be inserted
in the position 0º
Turn a
few degrees to allow fixing
PL-48S_2 to the rigging system
the piece G2A48
PL-48S_2
4
1
8
8
9
2
3
6
8
8
9
9
9
5
7
8
With the number 5, 6,7 and 8 boxes resting
on each other, the safety pins that define the splay
angle can be removed (8) and the PL-48S_2 guides
can return to their stored position (9). It is mandatory
to remove the safety pins between boxes 3-4, but
between 4-5, and 5-6, they can be left in place with
theanglepreparedforthenextevent.