User Manual

STACK
FLY
For flying boxes and defining the splay
angle, the pins must be inserted in the of guide 2,
G2A48, whereas for stacking ( ), the pin goes
throughthe oftheguide.
slot
top hole
stacked
All of the elements needed to rig or stack the
systems are integral to the enclosure (
and the quick release safety pins). The additional
items needed are the AX-AERO48 or AX-AERO38
flying grids (bumper bars), chains and hoists, the PL-
38 or PL-48S dolly platforms and the AX-COMBO
G1A48, G2A48
A) AX-AERO48 and AX-AERO38
The AX-AERO48 grid is made from 100 x 50
x 6mm steel beams and is designed to handle great
loads. It features a center reinforcement bar that is
also used for the lifting slings. The force of both the
rear and the front chain hoist will determine the tilt
angle of the whole array. The structure will be
attachedtothefirstenclosure of the array by means of
the guides G1A48, G2A48, and six quick release
safetypins.
Weight
Dimensions: 144x93x10 cm
(HxWxD)
: 75Kg (165 lbs)
57x36.6x4 in
Pickup points
Aero-38 Manual del usuario/ User´s manual 45
The AX-AERO38 grid is lighter than the other one, and
it is recommended to be used to fly a maximum of 8
cabinetsAERO-38A or 6 AERO-48.
Weight
Dimensions: 147x62x10 cm
(AlxAnxP)
: 60Kg (132 lbs)
57.8x24.4x4 in
For example, if 12 units AERO-48 are going
to be flown from the AX-AERO48, each hoist to be
usedshouldhavealoadcapacityof2ton.
>750Kg
>750Kg
>750Kg
1 6units-->
1 6units-->
1 8units-->
AERO-48
AERO
182
AERO-38
AX-AERO38
AX-AERO48
>1000Kg
>1000Kg
>750Kg
>2000Kg
>2000Kg
>1500Kg
1 8units-->
1 8units-->
1 10units-->
9 16units-->
9 16units-->
11 20units-->
AERO-48
AERO
182
AERO-38
Load capacity per hoist (safety factor 10:1)
B) Chain hoists
All units in a column will be flown from the
AX-AERO48 (AX-AERO38) flying grid (bumper bar),
which should be used with two hoists, one located in
the front and the other in the rear. Each hoist should
have a minimum of 1 Ton load capacity when flying up
8 units and a 2 Ton load capacity when flying 9 to 16
units.
C) Platforms PL-48 and PL-38
The PL-38 dolly panels facilitate transport of
the AERO-38 systems. They can also be used to
facilitate flying the systems. Each cover is attached to
the enclosure by using the flying hardware attached
to each box and is fixed with the quick release safety
pins. The AERO-182 systems also include one PL-48
dollypanelpercabinet.
AERO-182
PL-48
AERO-38
PL-38