User guide

AudioCore Version 8.40
AudioCore Version 8.40AudioCore Version 8.40
AudioCore Version 8.40 Page 17
The Device Window and Editing Blocks
A window for each unit connected to the system will be
available. All types of unit share the same format of window
with the following common features.
The ‘ID’ number shown in the top left hand corner of the
coloured window is the communication channel that the
device is using, with the type of device shown opposite this.
The signal flow chart shows the processing blocks available
for editing and is dependent on the type of device. To edit
any block, simply click on it.
Devices may be minimised to reduce the complexity of the screen if many units are connected. AudioCore is capable of
supporting up to 32 units on any one system.
The screen-shot above shows a typical system with three devices connected. Note that one device is minimised (bottom
left) to reduce the complexity any devices that do not need to be adjusted regularly may be kept minimised in this way.
This layout will be remembered when the file is saved, and will be preserved the next time the software is run.
Devices may be deleted from the system by clicking on the standard Windows red cross in the top right hand corner of
the respective window – a confirmation warning message is displayed prior to the deletion.