User guide

Page 34 AudioCore Version 8.40
AudioCore Version 8.40AudioCore Version 8.40
AudioCore Version 8.40
When storing any EQ combination, all memories are shown; when recalling,
only those of that particular type, or memories containing at least those
elements will be listed. In this example, choosing to recall memories of type
“Input and Xover” will show numbers 01 and 11 in addition to 02 and 09
which contain just Input and Xover settings as it is possible to recall just these
parts out of another combination memory.
Snapshot memories are accessed from the menu bar under Snapshots heading, or directly for store and recall using the
buttons on the toolbar:
Store a snapshot.
Recall a snapshot.
What actually happens when a snapshot is taken or recalled, is that the entire settings for each unit (for example Input,
Graphic AND Crossover settings on a 4 Series unit, or Input AND Crossover on a DP224/6/6i) are stored into a memory,
at the same location on each unit, and with the same name.
Selecting “Store” will display a window with the names listed
from the first device in the system. This assumes that
snapshots have been the method of storage used before, and
so the names on all units should be the same. Indication is
however given as to whether any units contain settings (not
complete snapshots necessarily) at certain locations.
Note that only location 01 has a system-wide snapshot stored,
indicated by all three bars being present.
Locations 02 – 08 have some memories stored in them on
some units in the system, but not all (greyed out).
Location 09 is completely empty in all units on the system.