User guide

AudioCore Version 8.40
AudioCore Version 8.40AudioCore Version 8.40
AudioCore Version 8.40 Page 39
For the purposes of this
description, 14 units are
connected to the
system, and are
identified above by the
colour-coded available
unit buttons, with ID
numbers as shown.
Hovering over the
buttons will display the
respective unit’s name.
Note the pair of large
buttons on the right
hand side – currently
the ‘SETUP’ mode is
active. The other
mode, ‘LIVE’ mode, is
designed to be used during a show. Swapping between the two modes is a password protected operation, with the
options available in ‘LIVE’ mode being decided whilst in ‘SETUP’ mode. These two modes may be thought of as
equivalent to user (‘LIVE’) and supervisor (‘SETUP’) modes in the normal Audiocore software.
It is possible to recall five snapshots across the entire system, the names of which appear in the ‘Snapshot Memories’ pane
in the middle of the window. These names are not downloaded from a unit – they will be the names last stored to any
unit connected to the system.