User guide

AudioCore Version 8.40
AudioCore Version 8.40AudioCore Version 8.40
AudioCore Version 8.40 Page 41
Control and Details of Zones
Referring to the master window, pressing one of the zone group buttons will display a zone control window with four
zones available at any time.
The name of the zone appears at the top of the strip, followed by its gain control and “Set 0dB” button, gain readout,
mute button, and zone solo button.
Additionally there is a 'Zero Zone’ function which temporarily removes Array Control’s contribution to all the outputs in
the zone. Toggling this button will restore the original gain setting. The MUTE ALL button, due to its possibly dangerous
function, has a ‘press and hold’ function associated with it. It will illuminate if briefly pressed as a warning, and then
permanently after about two seconds. The toggling off of this function also has a slight delay for safety purposes.
Beside the solo button is the ‘Detail’ button. Pressing this allows
access to some setup parameters for the zone, including the name
displayed at the top of the zone’s channel strip.
The list shown details all the outputs included in this zone, alongside
icons that are used to denote the metering point.
This icon means normal assignment of the output
This means the channel is the selected metering point for the
zone and is actually in the zone
This means the channel is selected for the zones metering
point but is not actually in the zone.
Changing the metering point is achieved by pressing the ‘Select Zone
Meter’ button and choosing the point required.