User guide

AudioCore Version 8.40
AudioCore Version 8.40AudioCore Version 8.40
AudioCore Version 8.40 Page 53
Installation
Set up the Netgear card first: Install the Netgear driver for the WG511T using the supplied Netgear driver disk
BEFORE plugging the card into your PC or laptop. Follow the instructions on screen. Now plug the card in – Windows
should recognise it and load the drivers as required. If, after installation, Windows then asks to load drivers itself, or
reports new hardware found, it is now safe to follow these instructions. If a warning is displayed select ‘Continue
Anyway’.
Set up the Wiser converter: There are no drivers required for the Wiser. All that needs to be done is to plug it into your
4 Series, DP226, DP224, or DP6i, using the lead with the RED band, plug in the power supply, and check the settings as
described below.
These settings are already programmed into the Wiser for you.
Set up the Master unit: The Master unit is the first one in the chain, and has the Wiser directly connected to it This unit
will need to have the Wiser enabled, as explained below.
Press MENU and use BACK and NEXT to navigate to
<
<<
<-
--
- MAIN Menu: . . . . . .
MAIN Menu: . . . . . . MAIN Menu: . . . . . .
MAIN Menu: . . . . . . -
--
->
>>
>
Interface Sub
Interface SubInterface Sub
Interface Sub-
--
-Menu
MenuMenu
Menu
and press ENTER.
Then choose
<
<<
<-
--
- INTERFACE Menu: . . .
INTERFACE Menu: . . . INTERFACE Menu: . . .
INTERFACE Menu: . . .
PC Interface Setup
PC Interface SetupPC Interface Setup
PC Interface Setup
and press ENTER.
Follow the wizard and ensure that the unit is set up as:
RS232 Mode, 38400 baud, ID1, Stop Prg Change: Yes, and Wiser Wireless is selected as Yes.
[4 Series Interface Menu]
Or…
Master, RS232, 38400 baud, ID1, Midi Relay : No, Stop Prg Change: Yes, and Wiser Wireless is
selected as Yes.
[DP224/6 Interface Menu]
Other units on the network should be set up as
Slave, RS485, 38400 baud, ID2 (increment ID for each connected unit).
[4 Series Interface Menu]
Or…
Slave, RS485, 38400 baud, ID2 (increment ID for each connected unit).
[DP224/6 Interface Menu]
In the case of a DP6i, set the interface to 09, which is the same as Master on RS232 at 38400 baud. The DP6i does
not have the facility to adjust the settings of Wiser. Further DP6i units should be set to interface
06 with incremental IDs.
Warning: The 4 Series by default are set to 115200 baud and this must be changed to 38400 for the system to work
.