User’s Manual convert 15A series Antes de utilizar el equipo, lea la sección “Precauciones de seguridad” de este manual. Conserve este manual para futuras consultas. Before operating the device, please read the “Safety precautions” section of this manual. Retain this manual for future reference.
CONTENTS SAFETY PRECAUTIONS 3 WARRANTY 4 DECLARATION OF CONFORMITY 5 6a7 INTRODUCTION 8a9 CONFIGURATIONS TM Without DASnet With DASnetTM 10 LINE DRAWINGS 11 a 13 AMPLIFIER Description ON / OFF Overload indicator Equalization Overheating Low mains voltage Current consumption Troubleshooting CHANGE OF CONFIGURATION SPECIFICATIONS 14 a 17 18 19 a 20 RIGGING SYSTEM 21 APPENDIX Line connections: unbalanced and balanced Manual del Usuario / action active / User’s Manual
convert 15A series Precauciones de Seguridad Safety Precautions Cajas acústicas activas / Self-powered loudspeaker enclosures El signo de exclamación dentro de un triángulo indica la existencia de importantes instrucciones de operación y mantenimiento en la documentación que acompaña al producto. Conserve y lea todas estas instrucciones. Siga las advertencias.
GARANTÍA Todos nuestros productos están garantizados por un periodo de 24 meses desde la fecha de compra. Las garantías sólo serán válidas si son por un defecto de fabricación y en ningún caso por un uso incorrecto del producto. Las reparaciones en garantía pueden ser realizadas, exclusivamente, por el fabricante o el servicio de asistencia técnica autorizado. Otros cargos como portes y seguros, son a cargo del comprador en todos los casos.
DECLARACIÓN DE CONFORMIDAD DECLARATION OF CONFORMITY D.A.S. Audio, S.A. C/ Islas Baleares, 24 - 46988 - Pol. Fuente del Jarro - Valencia. España (Spain).
INTRODUCTION The new convert 15A serie arrayable loudspeaker is a powered, multi-purpose system incorporating a series of breakthrough features that offer an unmatched level of versatility and performance. As its name implies, the system's coverage capabilities can be easily “converted” to meet the specific requirements of almost any application.
Horizontal dispersions according DCDTM 20º TM Remote monitoring is provided by way of the DASnet monitoring system and software, an audio management application for D.A.S. powered cabinets and processors. TM The DASnet software offers users instant and intuitive control over a range of parameters of a single cabinet or processor via USB, or a network of them via RS485. The wide frequency range and impressive output of the convert 15A is possible thanks to the D.A.S. built transducer components.
Manual del Usuario / convert 15A series / User’s Manual 3 x SX-218A POWER SUPPLY Vertical Coverage 60º Horizontal Coverage 60º (3x 20º DCDTM) POWER SUPPLY POWER SUPPLY 3 x Convert 1560A POWER SUPPLY 60º 60º A 1 B 2 6 DSP-2060 5 6 x Convert 1560A 6 x SX- 218A POWER SUPPLY 3 x SX-218A POWER SUPPLY 3 x Convert 1560A POWER SUPPLY POWER SUPPLY 60º 60º CONFIGURATIONS Below, two example configurations. In our website you can find more settings.
POWER SUPPLY 3 x SX-218A POWER SUPPLY POWER SUPPLY 60º IN OUT IN DASnet IN OUT Audio IN DASnet IN OUT Audio IN DASnet 1 IN OUT IN 1 Audio OUT IN OUT Audio IN DASnet OUT OUT OUT OUT 2 2 IN Audio IN DASnet IN Audio IN DASnet OUT OUT OUT OUT I o 3 3 IN OUT IN OUT L2 L1 L3 DSP-2060 FI40 30mA 4pol. FI-Schalter 6 x MCB 16A “C” 1pol. 1 x RCD 40A 30mA 4pol.
LINE DRAWINGS 10 convert 1560A Bottom View convert 1590A Bottom View convert 1560RA Bottom View convert 1590RA 595 904 ALL DIMENSIONS IN MILIMETERS Bottom View 418 Right View Rear View Right View Rear View Right View 418 Rear View Right View 418 Rear View 904 595 Front View 418 640 934 Front View 934 640 Front View Front View Manual del Usuario / convert 15A series / User’s Manual
AMPLIFIER 8 Description 9 7 1) INPUT : XLR-type input signal connector. This is a balanced connector just like the LOOP THRU connector with the following pin assignments: 1 =GND (ground). 2 =(+) Non inverted input. 3 =(-) Inverted input. 2) LOOP THRU : XLR-type output signal connector for connecting several units together and sending them all the same signal. 3) IN : RJ45 connector for DASnetTM input.
ON / OFF A sound system should be switched on sequentially. Switch on the self-powered units last in your sound system (switch on the subwoofer before the mid-high system). Switch on the sound sources such as CD players or turntables, then the mixer, then the processors, and finally the selfpowered unit. If you have several units, it is recommended that you switch them on sequentially one at a time.
Troubleshooting PROBLEM CAUSE No sound from the unit. The SIGNAL LED does not light up. SOLUTION 1 – The signal source is sending no signal. 2 – Defective cable. 3 - The amplifier has overheated. 1 – Check that the mixer or sound source is sending signal to the UNIT. 2 – Check that the cable from the sound source to the UNIT is connected correctly. Replace the cable if defective. 3 - Allow the unit to cool down for some minutes and it will function again.
CHANGE OF CONFIGURATION The unit, convert 1560A or convert 1590A, has default settings from the factory. We can change some default set parameters. The firmware described here is version 2.60. However, parameters such as gain and delay can be changed only by DASnetTM. As indicated on the back label of the unit to unlock, press and hold 'OK' for 2 seconds, until the arrows cover the entire screen and then we can access the treble gain menu, or high-pass filter menu, etc, to make changes.
If we have chosen point source, pressing the right arrow, we move on to a second menu. OK The absence of a down arrow indicates that an option is fixed, no more alternatives than 1 unit. However, if we choose curved source, pressing the right arrow, we move on to a second menu where you can select from 1 to 4 units (default 1 unit). OK OK Press ‘OK’ for exit. Also, if you press on the right arrow, we go to a new menu where you can choose the treble attenuation if desired (default is attenuated: 0 dB).
OK Press ‘OK’ for exit. Also, if you press on the right arrow, we go to a new menu where you can choose a high-pass filter or not (default: OFF). OK OK Press ‘OK’ for exit. If you press on the right arrow, we go to other menu. Afterwards, we can go to the left arrow only or exit. Also, if the menu shows ‘Configuration’ we go to the menu ‘Utilities’ by pressing the right arrow. If you press ‘OK’, we go to this menu.
Finally, if the menu shows ‘Utilities’ we go to the menu ‘Infomation’ by pressing the right arrow. If you press ‘OK’, we go to this menu. OK Then, automatically, the display will show the information of the unit, without pressing any buttons. And will automatically stop once the last screen is reached. Press ‘OK’ to repeat the sequence.
SPECIFICATIONS AC INPUT: PowerCON TRUE1 AC OUTPUT: PowerCON TRUE1 AC INPUT: PowerCON TRUE1 AC OUTPUT: PowerCON TRUE1 Product improvement through research and development is an ongoing process at D.A.S. All specifications are subject to change without notice.
RIGGING SYSTEM Warning This manual doesn’t contain all needed information for flying convert 15A systems. The present manual due to the numerous combinations possible, only contains a resume of the elements and the safety precautions. Please, see the Rigging Manual for more information. To perform any operations related to flying the system, read the Rigging Manual first, and act on the warnings and advice given.
Manual del Usuario / convert 15A series / User’s Manual CONVERT 1560A CONVERT 1590A CONVERT 1560RA CONVERT 1590RA AXA-CV15 AX-CONVERT15B AX-CONVERT15 VERTICAL ARRAY AXA-CV15 AXA-CV15H AXA-CV15H UNIVERSAL FLY BAR UNIVERSAL FLY BAR HORIZONTAL ARRAY
APPENDIX: Line connections: unbalanced and balanced There are two basic ways to transport an audio signal with microphone or line level: Unbalanced line: Utilising a two conductor cable, it transports the signal as the voltage between them. Electromagnetic interference can get added to the signal as undesired noise. Connectors that carry unbalanced signals have two pins, such as RCA (Phono) and ¼” (6.35mm, often referred to as jack) mono.
UM_CV15A_01_EN www.dasaudio.com D.A.S. AUDIO, S.A. C/. Islas Baleares, 24 46988 Fuente del Jarro Valencia, SPAIN Tel. 96 134 0525 Tel. Intl. +34 96 134 0860 Fax 96 134 0607 Fax Intl. +34 96 134 0607 D.A.S. AUDIO OF AMERICA, INC. Sunset Palmetto Park 6816 NW 77th Court. Miami, FL. 33166 - U.S.A. TOLL FREE: 1-888DAS4USA Tel. +1 305 436 0521 Fax +1 305 436 0528 D.A.S. AUDIO ASIA PTE. LTD. 25 Kaki Bukit Crescent #01-00/02-00 Kaki Bukit Techpark 1 Singapore 416256 Tel.