Product Info

Page 13/26
2.6. Position and minimum size of the areas protected by the WORK AIR
DL001 T U
Table 5 below indicates the minimum size of the protected areas and shows the positions of
the body areas protected by the WORK AIR DL001 T protective device.
Table 5 - Position and minimum size of the airbag protected areas
Protector
identification
code
Back Area
(CB Central Back)
Chest area (DC = Divided Chest)
Waist-Shoulder
A
(cm)
F
(cm)
Type
r
(mm)
L1
(mm)
l2
(mm)
H1
(mm)
WORK AIR
DL001 T U.1
41 - 46
33,1
11,5
TYPE A
25
42
84
118
WORK AIR
DL001 T U.2
46 - 51
36,7
12,8
2.7. Use, integrity and efficiency of the WORK AIR DL001 T U device
The functions for which the WORK AIR DL001 T U was designed will only be performed
correctly if it is registered and worn correctly and switched on.
We recommend that you inspect the device carefully prior to each use to check integrity and
that you REFRAIN from use whenever any parts show signs of evident wear or malfunction,
until complete functionality is restored.
In particular, check that the fastening and adjustments systems operate correctly.
Should any breaks or cracks occur through use, or if the integrity of the materials forming the
product is compromised, including accessory parts, have the integrity and efficiency of the
product checked by DAirlab assistance service, through the retailer where it was purchased.
In the event of impact and/or triggering, replace the device with a new WORK AIR DL001 T
U.
IMPORTANT:
●●● The WORK AIR DL001 T U serves to reduce the risk of injury by limiting the impact
force transferred in the event of a fall and impact against an obstacle. However, it is
stressed that no protector is able to protect from twisting, bending or extreme
movements. No back protector can provide protection against serious injuries of the
spinal column. NO PROTECTIVE DEVICE CAN PROVIDE PROTECTION AGAINST ALL
POSSIBLE IMPACT IN ACCIDENTS AND THEREFORE CANNOT PROVIDE COMPLETE
PROTECTION AGAINST INJURIES.