Product Info

Page 23/26
4. MAINTENANCE OF THE WORK AIR DL001 T U SYSTEM
4.1. Overview
The WORK AIR DL001 T U System has been designed and produced according to high
quality standards to ensure correct operation over time. However, it advisable to carry out
periodic maintenance on the system, consisting of a few simple operations.
4.2. Washing the WORK AIR DL001 T U
The WORK AIR DL001 T U must only be cleaned using a damp cloth with water or with
water and a conditioner-free neutral soapy solution.
Remove the soapy solution using a soft cloth dampened with fresh cold water only.
Do not rub with abrasive materials and do not leave the device to soak.
Leave the device to dry hanging, away from direct sources of light and heat.
Also refer to the instructions and international care symbols on the label affixed to the device,
listed in Table 7 below.
Table 7: List and meaning of international care symbols on the label affixed to the device
1 2 3 4 5
1. THIS GARMENT CANNOT BE WASHED IN WATER
2. THIS GARMENT CANNOT BE TREATED WITH CHLORINE
3. THIS GARMENT CANNOT BE TUMBLE DRIED
4. THIS GARMENT CANNOT BE IRONED
5. THIS GARMENT CANNOT BE DRY CLEANED
WARNINGS:
● Do not immerse the WORK AIR DL001 T U in water or other liquids. Immersing the WORK
AIR DL001 T in water or other liquids could cause irreparable damage to the electronic
components of the System.
● Do not iron the WORK AIR DL001 T U
● Do not wash under running water.
● Do not use solvents or other chemical substances for cleaning.
● Do not paint the protective device, or use dyes of any kind on it.
● Avoid or limit the exposure to UV rays, moisture and ice.
● Do not expose the device to high or low temperatures.
● Never tamper with any part of the device.
● Do not bend or twist the device as these actions constitute improper use for which the item
has not been designed; in fact, this could cause loss of its protective properties or breakage.
Therefore, DAirlab will not accept claims or requests for replacement of Devices that it finds
have been used improperly.
● When not in use, the protective device must be stored in a dry and well ventilated place
where it is not subjected to impact or pressure.
● Avoid storing the device with its weight concentrated in only a few points.
● Should the WORK AIR DL001 T U be used in the event of rain, protect the System with a
rainproof jacket worn over it.
● After use, if necessary leave the device to dry in a ventilated place at room temperature;
do not use hair dryers or other heating devices.