Product Info

Page 24/26
4.3. Transportation
Store and transport the device using the bag provided at the time of purchase.
WARNINGS:
●●● Always make sure that the system is placed in “Lock Mode” to prevent the
System from being switched on accidentally during transportation.
●●● Always make sure that the system has been switched off using the on/off button
to prevent accidental triggering of the System.
●●● Due to the presence of gas generators and related triggering system, air transport
might be prohibited or subject to special transport procedures. Before shipping your
WORK AIR DL001 T by air, check with the airport authorities and with the airline to
find out the correct procedure to follow.
4.3.1. Managing “Lock Mode”
If you wish to place the system in “Lock Mode” or reactivate it from “Lock Mode”, download
and use the specific software.
WARNING:
●●● With the system in Lock Mode it is not possible to switch on the system using
the on/off button.
4.4. Change of ownership
If you intend to sell your WORK AIR DL001 T U to a third party, place the system in “Lock
Mode” using the specific software, so that the new owner can register it as described in
Chapter 3.2 Registering the System after purchase.
WARNING:
● To ensure correct traceability for updates/notifications/recalls the system must be placed
in “Lock Mode” so that the new owner registers it correctly.
5. ROUTINE MAINTENANCE
5.1. 5.1. Routine maintenance of the System
Contact the DAirlab Assistance Service once every 3 years to request a maintenance check
or servicing (for a fee) of any components subject to wear.
5.2. Updating the electronic control unit of the WORK AIR DL001 T U
As described above, the WORK AIR DL001 T U has an internal electronic control unit that
manages airbag inflation in the appropriate circumstances. The firmware of the electronic
control unit may be updated from time to time to improve its performance or to offer the user
new features. New features may regard an expansion of the fall recognition functionalities,
or also the addition of new functions.
The firmware can be updated by the registered final user using the software available in their
personal area at the link: https://dairlab.com/signin, or during operations by DAirlab at the
headquarters in Via dell’Economia 64 /c 36100 Vicenza (VI), Italy.
In the future there may be other ways of updating the firmware; in this case consult the
DAirlab website.