Full Product Manual

Page 4
OPERATING INSTRUCTIONS
Release Tank Pressure
Pressure Release Valve (PRV) on select models
1. NO PRV: Lay the tank on its side with the hose
outlet on the bottom. Direct the nozzle away
from you and squeeze the shut-o lever until
the unit stops spraying. (See Figure I)
2. WITH PRV: Pull up on the knob of the PRV until
all pressure is released from the tank.
(See Figure J)
Filling
IMPORTANT: Always make sure the pressure is
released from the tank before lling or servicing.
If equipped, pull up on the knob of the pressure
release valve until all the pressure is released
from the tank. Otherwise, squeeze and hold
shut-o lever until the unit stops spraying. Then,
and only then, it is safe to remove pump.
1. Turn the pump handle counterclockwise to remove
the pump (See Figure E).
2. Fill the tank to the desired level. See ll markings
on side of tank. (Always refer to chemical
manufacturer for proper mixture).
3. Install the pump into the tank opening and turn
clockwise until tightly sealed against the tank
(See Figure F).
Figure FFigure E
Pressurizing
1. Make sure shut-o lock is not engaged. (If shut-o lock is engaged while pressurizing, the unit
will immediately start spraying).
2. Push down on the handle and turn counterclockwise to unlock the handle (See Figure G-1G).
3. Pressurize the sprayer by pumping the handle in a smooth up and down motion (See Figure G-2G).
4. Push down on the handle and turn clockwise to lock the handle into the pump (See Figure G-3G).
Spraying and Locking
1. Direct nozzle away from you and squeeze shut-o
lever to begin spraying.
2. For continuous spraying, squeeze lever and rotate
lock (See Figure H).
3. Unlock if needed and release shut-o lever to stop
spraying.
4. Turn the nozzle tip to adjust the spray pattern.
Figure H
LEVER
Figure G
1G
2G
3G
Figure I
Figure J