Measurement Guide

plain

Before

After

How to apply

sticky back plastic

Tools for the job

Remove doors and handles

Measure the door and cut to size allowing enough

extra to wrap around the edges.

(The handy grid on the backing paper makes

measuring and cutting in straight lines easier)

For neat corners, cut diagonally into the corner with scissors. Fold one flap around the corner, then the other. You will

be left with a small triangular excess which can be trimmed away with your scalpel, then wrap the rest of the excess

film over the edge to the inside of the door, this can be trimmed later if you prefer. Repeat for all 4 corners & sides

Peel away a small section of backing paper

and stick the film into place. Gradually peel

away the rest of the backing paper little by little,

smoothing out to the sides as you go. If you

make a mistake simply peel back and start again

Hang doors back into place, re-attach the

handles, stand back and admire your handy work!

Air bubbles can be pushed out to the side or for

small bubbles, prick with a pin to release the air.

Tip ! If your cupboard doors aren’t flat (eg shaker style),

use a hairdryer on a low setting to warm the film so

it moulds into the shape of the cupboard door

Clean thoroughly to remove any grease and dust