User's Manual

Table Of Contents

Frequency:

Select the network fre-

quency from these options:

Auto; b 2.4GHz; b/g

2.4GHz; or a 5GHz.

Profile IP Settings:

You can Enable or Disable the IP Settings portion of your profile here. If you

select Disable you will need to configure the IP address information each

time you connect to a network. If you select Enable you will maintain the

same IP address information each time you connect to a network.

Starting Ad-Hoc Network:

If you are configuring an

Ad-Hoc network, select

2.4GHz or 5GHz.

Select Auto or 1-11.

Ad-Hoc Channel:

Using the Configuration Utility (continued)

Data Packet Parameter:

Set the Fragmentation Threshold and the RTS Threshold. Please see below.

Fragmentation Threshold:

This value should remain at its default setting of 2346. If you experience a high

packet error rate, you may slightly increase your fragmentation threshold within

the value range of 256 to 2346. Setting the fragmentation threshold too low

may result in poor performance.

This value should remain at its default setting of 2346. If inconsistent data flow

is a problem, only a minor modification should be made.

RTS Threshold:

Advanced

Power Mode:

Disable - Saves no power.

Fast Save - Moderate power-saving.

Max Save - Saves the most power.

Select Enable or Disable.

Launch Utility on Startup:

Enable or Disable.

Super A/G:

Ad-HocAd-Hoc

Ad-Hoc