Dual-Band (draft) Wireless Network Adapter User Manual Model: GL2554MP-0A version 1.
Manufacturer's Disclaimer Statement The information in this document is subject to change without notice and does not represent a commitment on the part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the quality, accuracy or fitness for any particular purpose of this document.
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The antenna should be integral if the end device is intended to be operated in 5.15 ~ 5.25GHz frequency range. As long as 2 conditions above are met, further transmitter test will not be required.
Driver Installation Step 1: Insert the Dual-band Wireless Network Adapter into your computer. Windows Found New Hardware Wizard will come up. Select the second option and click “Next” to continue.
Step 2: Select the driver to install. Click “Browse” to select the folder where you store the driver files. Click “OK” to continue. Click “Next” to continue.
Step 4: Driver Found Click “Continue Anyway” to continue
Step 3: Driver Installation Driver files are being saved to your Windows system.
Step 4: Driver Installation Complete Click “Finish” to complete the driver setup. The following message will appear as soon as you successfully installed the driver for your Dual-band wireless network adapter.
Utility Configuration Current Status Display the current settings such as Profile Name, Network Type, Wireless Mode, Current Channel, Link Status and Encryption type. Click on the “Advanced” button to change display details.
Profile Management Create profile for the common wireless networks that you get connected to. You may create new profile by clicking on the “New” button, and modify the existing profile settings by clicking on the “Modify” button. Click on “Scan Available Network” to scan for the nearby wireless network. Select the wireless network that you wish to get connected to and click “OK” to continue.
In “General” Tab, Enter “Profile Name”, and enter SSID for this profile. In “Security” Tab, select the security mode, and enter the WEP key if you enable the Pre-Shared Keys option. Click “OK” for the changes to be effective.
In the “Advanced” Tab, select the Power Save mode, Network Type and other advanced options. Click “OK” for the changes to be effective.
Diagno stics Display current statistics such as Transmitti ng and Receiving packets. Click on “Advance d Statistics” to display more detail information Click “Driver Information” to display driver version and other detail information.
Click on “Action” on the menu selection to access functions such as “Disable Radio”,
“Country Select…” and “Disable Tray Icon” Click “Options” to display current settings.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The users manual for OEM integrators must include the following information in a prominent location “ IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be colocated or operating in conjunction with any other antenna or transmitte
