User's Manual
Table Of Contents
- Product Overview
- Installation
- Configuration
- Access Point Mode
- Wireless Client Mode
- Router Mode
- Setup Wizard
- Internet Setup
- Wireless Setup Wizard
- Wireless Settings
- Network Settings
- USB Settings
- Virtual Server
- Application Rules
- MAC Address Filter
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- UPnP Settings
- Guest Zone
- DMZ
- IPV6 Settings
- Administrator Settings
- Time Settings
- System Settings
- Firmware Update
- System Check
- Schedules
- Device Information
- Wireless
- Logs
- Statistics
- Internet Sessions
- IPv6
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Warranty
120D-Link DAP-1350 User Manual
Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the access point (192.168.0.50). Click
on Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Enterprise.
3. Next to WPA Mode, select WPA, WPA2, or Auto.
4. Next to Cipher Mode, select TKIP, AES, or Auto.
5. Next to RADIUS Server, enter the IP Address of your RADIUS server.
6. Next to Port, enter the port you are using with your RADIUS server.
1812 is the default port.
7. Next to Shared Secret, enter the security key.
8. Click Save Settings to save your settings.
Congure WPA/WPA2 Enterprise