User's Manual
Table Of Contents
- Product Overview
- Installation
- Configuration
- Access Point Mode
- Wireless Client Mode
- Router Mode
- Setup Wizard
- Internet Setup
- Wireless Setup Wizard
- Wireless Settings
- Network Settings
- USB Settings
- Virtual Server
- Application Rules
- MAC Address Filter
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- UPnP Settings
- Guest Zone
- DMZ
- IPV6 Settings
- Administrator Settings
- Time Settings
- System Settings
- Firmware Update
- System Check
- Schedules
- Device Information
- Wireless
- Logs
- Statistics
- Internet Sessions
- IPv6
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Warranty
146D-Link DAP-1350 User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP
server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK. (Windows® 7/ Vista® users type cmd in the Start Search box.)
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your access
point. Some rewall software programs may block a
DHCP request on newly installed adapters.
If you are connecting to a wireless network at a
hotspot (e.g. hotel, coffee shop, airport), please
contact an employee or administrator to verify their wireless network settings.