User's Manual
Table Of Contents
- Product Overview
- Installation
- Configuration
- Access Point Mode
- Wireless Client Mode
- Router Mode
- Setup Wizard
- Internet Setup
- Wireless Setup Wizard
- Wireless Settings
- Network Settings
- USB Settings
- Virtual Server
- Application Rules
- MAC Address Filter
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- UPnP Settings
- Guest Zone
- DMZ
- IPV6 Settings
- Administrator Settings
- Time Settings
- System Settings
- Firmware Update
- System Check
- Schedules
- Device Information
- Wireless
- Logs
- Statistics
- Internet Sessions
- IPv6
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Warranty
52D-Link DAP-1350 User Manual
Section 3 - Conguration
LAN Settings
This section will allow you to change the local network settings of the access point and to congure the DHCP settings.
My LAN
Connection is:
IP Address:
Subnet Mask:
Default Gateway:
Device Name:
Use the drop-down menu to select Dynamic
IP (DHCP) to automatically obtain an IP address
on the LAN/private network or select Static IP
to manually enter the IP settings.
192.168.0.50 is the default IP Address of the
DAP-1350.
255.255.255.0 is the default subnet mask. All
devices on the network must have the same
subnet mask to communicate on the network.
Enter the IP Address of the gateway in your
network.
Enter the Device Name of the AP. It is
recommended to change the Device Name if
there is more than one D-Link device within the
subnet.