User's Manual

55D-Link DAP-1350 User Manual
Section 3 - Conguration
Save to Local
Hard Drive:
Load from Local
Hard Drive:
Restore to Factory
Default:
Reboot the Device:
Use this option to save the current access point
conguration settings to a le on the hard disk
of the computer you are using. Click the Save
button. You will then see a le dialog where
you can select a location and le name for the
settings.
Use this option to load previously saved access
point conguration settings. Click Browse to nd
a previously saved conguration le. Then, click
the Upload Settings button to transfer those
settings to the access point.
This option will restore all conguration settings
back to the settings that were in eect at the
time the access point was shipped from the
factory. Any settings that have not been saved
will be lost, including any rules that you have
created. If you want to save the current access
point conguration settings, use the Save button
above.
N ote: Restoring the factory default settings
will not reset the Wi-Fi Protected Status to Not
Congured.
Click to reboot the access point.
System