User's Manual
Table Of Contents
- Product Overview
- Installation
- Configuration
- Access Point Mode
- Wireless Client Mode
- Router Mode
- Setup Wizard
- Internet Setup
- Wireless Setup Wizard
- Wireless Settings
- Network Settings
- USB Settings
- Virtual Server
- Application Rules
- MAC Address Filter
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- UPnP Settings
- Guest Zone
- DMZ
- IPV6 Settings
- Administrator Settings
- Time Settings
- System Settings
- Firmware Update
- System Check
- Schedules
- Device Information
- Wireless
- Logs
- Statistics
- Internet Sessions
- IPv6
- Help
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Warranty
68D-Link DAP-1350 User Manual
Section 3 - Conguration
Static IP
Select Static IP if all WAN IP information is provided to you by your ISP. You will need to enter in the IP address, subnet mask,
gateway address, and DNS address(es) provided to you by your ISP.
IP Address:
Subnet Mask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
MTU:
Clone MAC Address:
Enter the IP Address provided by your ISP
(Internet Service Provider).
255.255.255.0 is the default subnet mask.
All devices on the network must have the
same subnet mask to communicate on the
network.
Enter the IP Address of the gateway in your
network.
Enter the Primary DNS (Domain Name
System) server IP address assigned by your
ISP.
Enter the Secondary DNS (optional) server IP
address assigned by your ISP.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance
with your specic ISP. The default MTU size is 1500.
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your PC’s MAC Address
button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended that you change
the default MAC address unless required by your ISP.