User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Basic Settings
- Access Point Mode (2.4GHz) - Open System
- Access Point Mode (2.4GHz) - Shared Key
- Access Point Mode (2.4GHz) - WPA Personal
- Access Point Mode (2.4GHz) - WPA Enterprise
- Access Point Mode (2.4GHz) - 802.1X
- Access Point Mode (5GHz)
- WDS with AP Mode (2.4GHz)
- WDS with AP Mode (5GHz)
- WDS Mode (2.4GHz)
- WDS Mode (5GHz)
- Wireless Client Mode (2.4GHz)
- Wireless Client Mode (5GHz)
- Advanced Settings
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings - Ticket
- Authentication Settings - User/Password
- Authentication Settings - Remote RADIUS
- Authentication Settings - LDAP
- Authentication Settings - POP3
- Login Page Upload
- Web Redirection
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Uplink/Downlink Settings
- QoS
- Traffic Manager
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
D-Link DAP-2660 User Manual
30
Channel Width:
Captive Prole:
Remote AP MAC
Address:
Site Survey:
Authentication:
Allows you to select the channel width you would like to operate in. Select 20 MHz if you are not using any 802.11n wireless
clients. Auto 20/40 MHz and Auto 20/40/80 MHz allows you to connect to both 802.11n and 802.11b/g or 802.11a wireless
devices on your network.
Select the enable or disable the captive portal feature here.
Enter the MAC addresses of the APs on your network that will serve as bridges to wirelessly connect multiple networks.
Click on the Scan button to search for available wireless networks, then click on the available network that you want to
connect with.
Select the wireless authentication method to use here. In the WDS mode, the following authentication methods are supported:
Open System and WPA-Personal.
For more information about the wireless security, refer to page 14.