User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Basic Settings
- Access Point Mode (2.4GHz) - Open System
- Access Point Mode (2.4GHz) - Shared Key
- Access Point Mode (2.4GHz) - WPA Personal
- Access Point Mode (2.4GHz) - WPA Enterprise
- Access Point Mode (2.4GHz) - 802.1X
- Access Point Mode (5GHz)
- WDS with AP Mode (2.4GHz)
- WDS with AP Mode (5GHz)
- WDS Mode (2.4GHz)
- WDS Mode (5GHz)
- Wireless Client Mode (2.4GHz)
- Wireless Client Mode (5GHz)
- Advanced Settings
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings - Ticket
- Authentication Settings - User/Password
- Authentication Settings - Remote RADIUS
- Authentication Settings - LDAP
- Authentication Settings - POP3
- Login Page Upload
- Web Redirection
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Uplink/Downlink Settings
- QoS
- Traffic Manager
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
D-Link DAP-2660 User Manual
36
IPv6
This access point is IPv6 ready. An IPv6 address can be manually congured or automatically obtained from a DHCPv6 server. This IPv6 address is
only applicable to the LAN side of the local network and is not visible from the Internet.
Enable IPv6:
Get IP From:
IP Address:
Prex:
Default Gateway:
Select the checkbox to enable the IPv6 option of
this access point.
Select the method that will be used by this access
point to obtain an IPv6 address. Options to choose
from are Static and Auto. Select the Auto option
if this access point can obtain IPv6 settings from
a DHCPv6 server on the local network. Select the
Static option to manually enter the IPv6 settings
in the spaces provided.
Enter the IPv6 address for this access point here.
Enter the IPv6 prex value for this access point
here.
Enter the default gateway’s IPv6 address here.