User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Basic Settings
- Access Point Mode (2.4GHz) - Open System
- Access Point Mode (2.4GHz) - Shared Key
- Access Point Mode (2.4GHz) - WPA Personal
- Access Point Mode (2.4GHz) - WPA Enterprise
- Access Point Mode (2.4GHz) - 802.1X
- Access Point Mode (5GHz)
- WDS with AP Mode (2.4GHz)
- WDS with AP Mode (5GHz)
- WDS Mode (2.4GHz)
- WDS Mode (5GHz)
- Wireless Client Mode (2.4GHz)
- Wireless Client Mode (5GHz)
- Advanced Settings
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings - Ticket
- Authentication Settings - User/Password
- Authentication Settings - Remote RADIUS
- Authentication Settings - LDAP
- Authentication Settings - POP3
- Login Page Upload
- Web Redirection
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Uplink/Downlink Settings
- QoS
- Traffic Manager
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
D-Link DAP-2660 User Manual
42
Wireless Resource (2.4GHz)
Wireless band:
Band Steering:
Band Steering Age:
Band Steering
Dierence:
Band Steering Refuse
Number:
Connection Limit:
Select the wireless band used here. Options
to choose from are 2.4 GHz and 5 GHz. In this
section we’ll explain the 2.4GHz wireless band.
This parameter can only be congured in the
5GHz band section.
This parameter can only be congured in the
5GHz band section.
This parameter can only be congured in the
5GHz band section.
This parameter can only be congured in the
5GHz band section.
Select to Enable or Disable the connection
limit feature here. This is an option for
load balancing and determines whether to
limit the number of users accessing this
device. The exact number is entered in the
User Limit eld below. This feature allows
the user to share the wireless network
trafc and the client using multiple APs.
If this function is enabled and when the
number of users exceeds this value, or
the network utilization of this AP exceeds
the percentage that has been specied,
the DAP-2660 will not allow clients to
associate with the AP.
The Wireless Resource Control window is used to congure the wireless connection settings so that the device can detect the better wireless
connection in your environment.