User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Basic Settings
- Access Point Mode (2.4GHz) - Open System
- Access Point Mode (2.4GHz) - Shared Key
- Access Point Mode (2.4GHz) - WPA Personal
- Access Point Mode (2.4GHz) - WPA Enterprise
- Access Point Mode (2.4GHz) - 802.1X
- Access Point Mode (5GHz)
- WDS with AP Mode (2.4GHz)
- WDS with AP Mode (5GHz)
- WDS Mode (2.4GHz)
- WDS Mode (5GHz)
- Wireless Client Mode (2.4GHz)
- Wireless Client Mode (5GHz)
- Advanced Settings
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings - Ticket
- Authentication Settings - User/Password
- Authentication Settings - Remote RADIUS
- Authentication Settings - LDAP
- Authentication Settings - POP3
- Login Page Upload
- Web Redirection
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Uplink/Downlink Settings
- QoS
- Traffic Manager
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
D-Link DAP-2660 User Manual
7
Hardware Overview
LEDs Connections
1
2
3
1 Reset Button
Press and hold for six seconds to reset the access point
to the factory default settings.
2 LAN (PoE) Port Connect to your network with an Ethernet cable.
3 Power Receptor Connect the supplied power adapter.
1 Power
The light blinks in red during boot up or malfunction,
and lights in solid red when the bootup is failed. The LED
lights in solid green when it is ready, and blinks in green
when the trace is passing through.
1