User's Manual
Table Of Contents
- Product Overview
- Hardware Overview
- Basic Installation
- Web User Interface
- Basic Settings
- Access Point Mode (2.4GHz) - Open System
- Access Point Mode (2.4GHz) - Shared Key
- Access Point Mode (2.4GHz) - WPA Personal
- Access Point Mode (2.4GHz) - WPA Enterprise
- Access Point Mode (2.4GHz) - 802.1X
- Access Point Mode (5GHz)
- WDS with AP Mode (2.4GHz)
- WDS with AP Mode (5GHz)
- WDS Mode (2.4GHz)
- WDS Mode (5GHz)
- Wireless Client Mode (2.4GHz)
- Wireless Client Mode (5GHz)
- Advanced Settings
- VLAN List
- Port List
- Add/Edit VLAN
- PVID Settings
- AP Array Scan
- Configuration Settings
- Auto-RF
- Load Balance
- Authentication Settings - Ticket
- Authentication Settings - User/Password
- Authentication Settings - Remote RADIUS
- Authentication Settings - LDAP
- Authentication Settings - POP3
- Login Page Upload
- Web Redirection
- Dynamic Pool Settings
- Static Pool Setting
- Current IP Mapping List
- Wireless MAC ACL
- WLAN Partition
- Uplink/Downlink Settings
- QoS
- Traffic Manager
- Status
- Stats Page
- Log
- Maintenance Section
- Administration
- Configuration and System
- System Settings
- Help
- Knowledge Base
- Troubleshooting
- Technical Specifications
D-Link DAP-2660 User Manual
97
Time and Date Settings
Enter the NTP server IP, choose the time zone, and enable or disable daylight saving time.
Current Time:
Enable NTP Server:
NTP Server:
Time Zone:
Enable Daylight
Saving:
Daylight Saving
Dates:
Set the Date and
Time Manually:
Displays the current time and date settings.
Check to enable the AP to get system time from
an NTP server from the Internet.
Enter the NTP server IP address.
Use the drop-down menu to select your correct
Time Zone.
Check the box to enable Daylight Saving Time.
Use the drop-down menu to select the correct
Daylight Saving oset.
A user can either manually set the time for the
AP here, or click the Copy Your Computer’s
Time Settings button to copy the time from the
computer in use (Make sure that the computer’s
time is set correctly).