Quick Installation Guide Nuclias Connect AX1800 Access Point DAP-X2810 Additional documentation is also available on the D-Link website
Contents English 1
System Requirements This installation guide provides instructions for installing the DAP-X2810 on your network. Additional documentation is also available on the D-Link support website. • • • Nuclias Connect Manual: For additional information and instructions on how to configure the device using Nuclias Connect. DAP-X2810 User Manual: For additional information and instructions on how to configure the device using the web user interface.
Interface Connectors Using a Power Adapter (Optional) ENGLISH 1. Connect the power connector of the adapter to the power input on the DAP-X2810 and plug the adapter into a nearby power outlet. Configuration Using Nuclias Connect 1 2 3 4 Figure 2: Rear Connectors # Connector Console 1 Port LAN(PoE) 2 Port 3 Power Input 4 Reset Description RJ45 console port for connection to a management computer. Gigabit RJ-45 port for data and Power over Ethernet (PoE) power.
Connecting Wirelessly 1. 2. ENGLISH 3. Connect the management computer to the default SSID of the DAP-X2810, “dlink”. Manage the access point from a computer. Enter dapx2810.local in the address field of your browser. Log in to the administration user interface. The default login information is Username: admin Password: admin Figure 4: Mounting the Device Mounting Mounting on a Solid Wall or Ceiling 5. Rotate the DAP-X2810 into the grooves on the mounting plate to secure it to the plate.
1. Clip the two ceiling brackets onto a ceiling crossbar. FCC: Operations in the 5.15-5.25GHz band are restricted to indoor usage only. ENGLISH Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 23.9 cm between the radiator & your body. NCC警語: Figure 6: Attaching the Mounting Plate 2. 3.
Appendix - Statements ErP Power Usage This device is an Energy Related Product (ErP) that automatically switches to a power-saving Network Standby mode within 1 minute of no packets being transmitted. It can also be turned off through a power switch to save energy when it is not needed. Network Standby: 4.93 watts Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
RF Frequency Requirements This device is for indoor use only when using all channels in the 5.15 to 5.25 GHz frequency range. High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device. This device will not operate on channels which overlap the 5600-5650 MHz band. It is restricted to indoor environments only.
Japan Voluntary Control Council for Interference Statement この装置は、クラス B情報技術装置です。この装置は、家庭環境で使用することを目的としてい ますが、この装置がラジオやテレビジョン受信機に近接して使用されると、受信障害を引き起こ すことがあります。 取扱説明書に従って正しい取り扱いをして下さい。 Japan Voluntary Control Council for Interference Statement This is a Class B product based on the standard of the VCCI Council. If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.
Notes
Notes
Ver. 1.
