Quick Installation Guide Access Point This document will guide you through the basic installation process for your new access point DBA-2720P Documentation is also available on the D-Link website
Before You Begin This installation guide provides instructions for installing the DBA-2720P on your network. Additional documentation is also available on the D-Link support website. • Hardware Overview LED Indicators D-Link Nuclias Access Point Portal Manual: For additional information and instructions on how to configure the device using the D-Link Nuclias cloud.
Configuring the Access Point Interface Connectors Using D-Link Nuclias 1 2 3 4 5 6 Figure 2: Rear Connectors # Connector Description 1 Reset Button Used for rebooting or resetting the device back to factory default settings. Used to power the device on and off. 2 Power Button 3 Power Input Input for the power adapter. 4 LAN Port 2 Gigabit RJ-45 port for data. 5 LAN Port 1 (PoE) Gigabit RJ-45 port for data and Power over Ethernet (PoE) power.
The default host name is http://DBA-2720PXXXX where XXXX represents the last 4 characters of the MAC address listed on the device label located on the bottom of the device. 3. When prompted, enter the default login credentials: User name: admin Password: admin Connecting Wirelessly 1. Connect the management computer to the default SSID of the DBA-2720P.
plate to the ceiling brackets. 3. Connect the Ethernet cable and power adapter (optional) to the device. 4. Attach the DBA-2720P to the mounting plate by placing it onto the plate and rotating clockwise until the device locks into place. Locking the DBA-2720P Attach a Kensington physical security lock to the Kensington slot on the side of the device to secure it to an object. device to load an alternate firmware.
Appendix - Statements ErP Power Usage This device is an Energy Related Product (ErP) that automatically switches to a power-saving Network Standby mode within 1 minute of no packets being transmitted. It can also be turned off through a power switch to save energy when it is not needed. Network Standby: 6.3792 watts Switched Off: 0.
IMPORTANT NOTICE: FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 25cm between the radiator and your body. Innovation, Science and Economic Development Canada (ISED) Statement: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Japan Voluntary Control Council for Interference Statement This is a Class B product based on the standard of the VCCI Council. If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual. 電波法により5GHz帯は屋内使用に限ります。 Product and Warranty Information To find out more about D-Link Nuclias product or marketing information, please visit the website http://www.dlink.com or https://www.nuclias.com.
