Quick Installation Guide

2
DBA-3621P Quick Installation Guide
ENGLISH
Interface Connectors
Label Area
1 2 3
Figure 2: Bottom Connectors
# Connector Description
1
LAN(PoE)
Port
Gigabit RJ-45 port for data and
Power over Ethernet (PoE).
2 Reset
Press and hold for 10 seconds to
factory reset the device.
3
Console
Port
Console port to connect to the
DBA-3621P using a RJ-45 to serial
cable.
Table 2: Interface Description
Label Area
1 2
Figure 3: Rear Connectors
# Connector Description
1
Wall/Pole
Mount
Mount to connect to the mounting
plate on a wall or a pole.
2
Grounding
Wire
Connector for the grounding wire.
Table 3: Interface Description
Installation
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect
the LAN1(PoE) port on the DBA-3621P
to a PoE power source device such as
an 802.3af or 802.3at PoE switch or PoE
injector.
Conguration
Using Nuclias Cloud
The DBA-3621P is designed to be managed
through the Nuclias Cloud. Refer to the Nuclias
Cloud Manual for detailed configuration
instructions. To use Nuclias Cloud, your device
must be connected to the Internet.
Note: D-Link recommends manually configuring
the device before mounting it.
Nuclias Cloud App Conguration
1. Download the free Nuclias Cloud app from
the App Store or Google Play by searching
for Nuclias Cloud.
2. Open the Nuclias Cloud app and follow
the onscreen instructions to discover and
set up your device.
Nuclias Cloud Web Conguration