Quick Installation Guide Access Point This document will guide you through the basic installation process for your new D-Link Nuclias Cloud-Managed AX1800 Access Point DBA-X1230P Documentation is also available on the D-Link website
ENGLISH Before You Begin This installation guide provides instructions for installing the DBA-X1230P on your network. Additional documentation is also available on the D-Link support website. • D-Link Nuclias User Manual: For additional information and instructions on how to configure the device using the D-Link Nuclias Cloud. • DBA-X1230P User Manual: For additional information and instructions on how to configure the device using the web user interface.
The DBA-X1230P can be powered using one of the following two methods: Refer to the DBA-X1230P User Manual for detailed configuration instructions. Use one of the following methods to access the web user interface: Using Power over Ethernet (PoE) Connecting through Ethernet Use a standard Ethernet cable to connect the LAN port on the DBA-X1230P to a PoE power source device such as a PoE switch or PoE injector.
ENGLISH Mounting on a Solid Wall or Ceiling 6. Slide the DBA-X1230P onto the mounting plate. 1. (Optional) Attach the included lock plate to the mounting plate using the included screws. Figure 4: Attaching the Lock Plate 2. Use the mounting plate to mark the location where to drill the holes in the wall or ceiling. Figure 8: Placing The Access Point Mounting on a Ceiling Crossbar 1. (Optional) Attach the included lock plate to the mounting plate using the included screws.
Troubleshooting The DBA-X1230P receives its configuration settings and is managed through the D-Link Nuclias cloud. If you are experiencing problems connecting to the D-Link Nuclias cloud, check your Internet connection. If you still cannot connect to the service, additional configuration on the device may be required. Refer to the DBA-X1230P User Nuclias Cloud Manual for detailed information on how to manually configure the device.
ENGLISH Appendix - Statements ErP Power Usage This device is an Energy Related Product (ErP) that automatically switches to a power-saving Network Standby mode within 1 minute of no packets being transmitted. It can also be turned off through a power switch to save energy when it is not needed. Network Standby: 7.27 watts Switched Off: 0.
ENGLISH IMPORTANT NOTICE: FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 23.7cm between the radiator and your body. Innovation, Science and Economic Development Canada (ISED) Statement: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
ENGLISH Japan Voluntary Control Council for Interference Statement This is a Class B product based on the standard of the VCCI Council. If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual. 電波法により5GHz帯は屋内使用に限ります。 Product and Warranty Information To find out more about D-Link products or marketing information, please visit the website http://www. dlink.com.
Ver. 1.
