Operation Manual

40D-Link DAP-1665 User Manual
Section 3 - Conguration
Wireless Mode:
Site Survey:
Repeater Network
Name:
Repeater Network
Band:
Channel Width:
Enable Wireless:
Repeater Network
Name:
Local Wi-Fi
Network Name:
Select Repeater from the drop-down menu.
Click Site Survey to display a list of wireless networks in your
area. To select a wireless network, click on the radio button in
the far right column, and click Connect at the bottom of the
page to continue. The wireless network name will automatically
appear in the Repeater Network Name eld below, and the
Repeater Network Band and Channel Width will automatically
be detected.
If you have not used the Site Survey button above, enter the
SSID of the access point you want to repeat the signal of.
If you have not used the Site Survey button above, select the
wireless band of the repeater network.
If you have not used the Site Survey button above, select the
channel width to be used for communication with the repeater
network.
Check the box to enable the 2.4 GHz wireless band. By default,
the schedule is set to Always, however you can select a schedule
from the drop-down menu, or click Add New to create a new
schedule.
Displays the name of the network to be repeated.
Choose how you would like to name the DAP-1665’s extended
network using the radio buttons:
Same as Repeater Name - The extended network will have the
same name (SSID) as the repeater network.
Create a New Wi-Fi Network Name - Enter a new name (SSID)
for the extended network in the eld below.
Repeater Mode
Repeater mode re-broadcasts the wireless signal of an existing network to increase coverage. The existing wireless signal can
be repeated by the DAP-1665 using both the 2.4 GHz and 5 GHz bands.
2.4 GHz Band