Operation Manual
49D-Link DAP-1665 User Manual
Section 3 - Conguration
DHCP Server
The access point has a built-in Dynamic Host Control Protocol (DHCP) server which can automatically assign IP addresses to
connected clients that request them. The DHCP server function will only be available when Static IP Address mode is used.
Enable DHCP
Server:
DHCP IP Address
Range:
Always
Broadcast:
Gateway:
WINS:
DNS:
DHCP Lease Time:
Dynamic DHCP
Client List:
Check the box to enable the DHCP server function.
Enter the range of the DHCP address pool from which requesting
clients can be assigned addresses. You should ensure that the
access point’s static IP address is outside of this range in order
to avoid any IP address conicts.
Check the box to have the DHCP server always broadcast its
response to clients. This can help to avoid problems when clients
fail to obtain an IP address from the DHCP server.
The gateway address which will be sent to requesting clients.
Enter the WINS server address which will be sent to requesting
clients.
Enter the DNS server address which will be sent to requesting
clients.
Select the desired DHCP address lease length time from the
drop-down menu.
This table will show details of clients which are currently
receiving a DHCP address from the DHCP server.
Click Save Settings at the top of the page to save the current
conguration.