Operation Manual

50D-Link DAP-1665 User Manual
Section 3 - Conguration
IPv6
The DAP-1665 can be congured to operate using the IPv6 protocol. If you are connecting the access point to a network which
is using IPv6, you should adjust the appropriate settings in this section.
My IPv6
Connection is:
LAN IPv6 Link-
Local Address:
Select Link-Local Only from the drop-down menu. This will set
the access point’s local IPv6 address.
The router’s local IPv6 address will be displayed here. This
address should be used to access the web-based conguration
utility through the IPv6 protocol.
Click Save Settings at the top of the page to save the current
conguration.
My IPv6
Connection is:
LAN IPv6
Address:
Subnet Prex
Length:
Default Gateway:
Primary DNS
Server:
Secondary DNS
Server:
Select Static IPv6 from the drop-down menu. This will allow
you to assign a static IPv6 address to the access point.
The router’s local IPv6 address will be displayed here. This
address should be used to access the web-based conguration
utility through the IPv6 protocol.
Enter the prex length for IPv6 IP addresses on your network.
Enter the default IPv6 gateway address for your network.
Enter the primary IPv6 DNS server address for your network.
Enter the secondary IPv6 DNS server address for your network.
Click Save Settings at the top of the page to save the current
conguration.