Quick Installation Guide

ManualsBrandsD-Link ManualsSmart HomeWhole Home Smart Wi-Fi Water Leak Sensor Starter Kit

What's in the Box

Pro Series

Whole Home Smart Wi-Fi

Water Leak Sensor Starter Kit

DCH-S162 A1

This is your device’s Setup Code.

Please keep it as future reference

for your device.

Simple Setup

Get the mydlink app on the App

Store or on Google Play. Launch the

app, then Sign In or Create a New

Account.

Battery-powered Remote

Water Sensing Pod

(DCH-S163)

Master Plug-in Smart Wi-Fi

Water Leak Sensor

(DCH-S162)

RJ11 Sensing Cable

Cable Clips

Setup Code

Power on the device and wait for

the Status LED to ﬂash orange.

Note: Make sure that your mobile device’s

Bluetooth is on.

Place your device next to your

mobile device. A prompt will appear

- tap Add Device, then follow the

app instructions.

mydlink

Please set up your device before mounting it.

Quick Installation Guide

Note: If not automatically prompted

within 30 seconds, tap then tap

Add Device.

Alerts

When water is detected from any of the

sensors connected to your whole home

water leak system, ONLY the Master

Plug-in Smart Wi-Fi Water Leak Sensor

(DCH-S162) will sound an audible

alarm and an alert will be sent to your

smartphone notifying you as to which unit

was triggered.

DCH-S163 pre-installed

with 2 AAA batteries

Summary of content (3 pages)

PAGE 1
DCH-S162 A1 Pro Series Whole Home Smart Wi-Fi Water Leak Sensor Starter Kit Quick Installation Guide Simple Setup Setup Code Please set up your device before mounting it. 1 Get the mydlink app on the App Store or on Google Play. Launch the app, then Sign In or Create a New Account. This is your device’s Setup Code. Please keep it as future reference for your device. mydlink 2 Power on the device and wait for the Status LED to flash orange. Note: Make sure that your mobile device’s Bluetooth is on.
PAGE 2
LED Behavior Placement FAQ If you haven’t already done so, ensure the DCH-S162 has been set up. Refer to the Simple Setup section for details. Status LED Strobe LED Connected to the network and mydlink Connect the supplied RJ-11 sensing cable to the RJ-11 port on the bottom of the DCH-S162. Booting up Note: If you need to further extend the sensing cable, you may attach additional RJ-11 cable(s).
PAGE 3
Attention FCC: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.