User manual

10D-Link DCS-6111 User Manual
Section 2 - Installation
Hardware Installation
WhenMountingtoaCeiling
Find a suitable place to install the camera using the alignment stencil. Place
the camera at the desired operating location and insert the screws through the
two holes located at the base of the camera. Use a screwdriver to tighten and
secure.
WhenMountingtoaWall
Find a suitable place to install the camera by using the alignment stencil to nd
a desired operating location on the wall. Drill two pilot holes where the holes
of the alignment stencil are located. Insert the supplied plastic anchors into
the drilled holes, and align the holes at the base of the camera with the plastic
anchors. Once aligned, insert the provided screws through the holes. Use a
screwdriver to tighten and secure.